BitMo 23 Watt 10-uator Kit "Box" for Mid Wattage Tube Amps

BitMo 23 Watt 10-uator Kit is an add-on speaker attenuator kit (parts and instructions) for any mid power tube amp with output up to 23 watts. Some examples are Fender Princton, Fender Deluxe, Marshall 18 watt, and many more.

The BitMo 23 Watt 10-uator Box is built in an ABS plastic box instead of a screw-on plate. It includes instructions for 8 or 16 ohm configuration and can also be used with 4 ohm amps.

The BitMo 23 Watt attenuator gives you control of the speaker volume so you can get great cranked tone from your amp at studio or bedroom levels. The voicing circuit prevents tone sucking! It also includes a variable level, speaker-voiced line output so you can plug directly into a mixer for recording or live performance. Better yet, you can use the whole amp as a pre-amp into another guitar amp. The kit is easy to build and comes with instructions and all required parts including a labeled faceplate. It requires no wiring modification to the amp. You will need an extra speaker cable. If no speaker is plugged into the output jack, a power soak resistor is switched into the circuit so you can safely use the amp as a preamp only.

This BitMo 10-uator is rated at 23 watts. The kit contains parts and instruction to allow configuration for 8 or 16 ohm speakers.

This version is also recommended if you are gigging with a hot-rodded Valve Junior or Blackheart.

Note: BitMo kits do not include tubes.

Tools you will need – screwdriver, soldering iron, solder, small eyeglass screwdriver, wire stripper, needle nosed pliers, drill and 3/8" bit.


Availability: Usually ships within 24 hours.

BM-23WATT-BOX$79.95